Land Pride CA2560 Manuel d'utilisateur télécharger pdf (Page 14)

Section 3: Operating Instructions

CA2560 & CA2572 Core Aerators 325-020M

12/06/11

Table of Contents

Leveling Adjustments

Check for levelness by parking tractor on a level surface

and lowering Aerator down until unit is approximately

1 to 2 inches off the ground. Place tractor in park or set

park brake, shut tractor off and remove switch key.

1. Place a level on the front mainframe tube. Level

mainframe from left to right by adjusting one of the

tractor’s lower 3-point arms up or down.

2. Without starting the tractor, lower tractor’s 3-point

hitch until all weight is off of tractor.

3. Rotate level 90 degrees and place across end of

mainframe. Adjust tractor’s top center link until

mainframe is level from front to back.

Transporting

CAUTION

When traveling on public roads at night or during the day, use

accessory lights and devices for adequate warning to

operators of other vehicles. Comply with all federal, state and

local laws.

1. Select a safe ground speed when transporting from

one area to another.

2. Be sure to reduce tractor ground speed when turning

and leave enough clearance so the equipment does

not contact obstacles such as buildings, trees or

fences.

3. Always raise Core Aerator up before traveling on

public roadways.

4. When traveling on roadways, transport in such a way

that faster moving vehicles may pass you safely.

5. Shift to a lower gear when traveling over rough or

hilly terrain.

NOTE: See Tractor Operator’s Manual for

instructions on how to adjust tractor’s lower 3-point

arms and top center link.

Un-hooking Core Aerator

The following steps should be done when un-hooking

Core Aerator from the tractor:

1. Park tractor and Core Aerator on a solid level

surface. Lower Aerator until approximately 6" off the

ground. Place tractor in park or set park brake, shut

tractor off and remove switch key.

2. See “Parking Stands” on page 9 for information on

adjusting them to the correct height. Lower parking

stands to the correct height and make sure wire

retaining pins are secured in place.

3. Without starting tractor, lower tractor’s 3-point hitch

until all weight is off of tractor.

4. Remove center hitch pin. Store hitch pin in a safe

location for reuse.

5. Remove lower hitch pins. Store lower hitch pins in

lower clevises for reuse.

6. Be sure implement is clear of tractor and then drive

tractor away from implement.

Storage

Clean, inspect, service and make necessary repairs to

the Core Aerator when parking it for long periods and

when parking it at the end of a working season. This will

help ensure that the Aerator is ready for field use next

time you hook-up to it.

1. Clean off any dirt and grease that may have

accumulated on the Core Aerator. Scrape off

compacted dirt. Clean out cores lodged in the spoon.

See “Cleaning the Spoons” on page 15.

2. When finished cleaning and scraping dirt and grease

off, wash the surfaces thoroughly with a garden

hose.

3. Repaint parts where paint is worn or scratched to

prevent rust. A coating of oil may also be applied to

the spoon to minimize oxidation.

4. Replace all damaged or missing decals.

5. Store the Core Aerator inside if possible. Inside

storage will reduce maintenance and make for a

longer Aerator life.

6. Inspect Core Aerator for loose, damaged or worn

parts and adjust or replace as needed.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Land Pride CA2560 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Véhicule utilitaire Land Pride CA2560